Chauvet Tiger DMX 60 Manual del operador descargar pdf (Pagina 57)

10. Running your show - Page 49

Pearl 2008 Manual - 16th July 2007

You can use “Record by channel” mode when programming to set some

memories to only affect position, and other memories to set colours,

gobos, add shapes, and so on. By combining two or more memories

you can produce a much wider range of effects than if all your

memories set all the attributes. However, for this to work well you need

to make sure you know what attribute is going to be affected by each

memory, as if you turn on two “colour only” memories then nothing is

going to light up.

10.5 Master faders

In the bottom left hand corner of the console are the Master Faders.

These allow overall intensity control of the whole console.

• The Add/Flash and Swop masters control the intensity of the Flash

and Swop buttons on the playbacks.

• The Preset Master controls the overall intensity of any channels

turned on in the Preset faders.

• The Grand Master controls the intensity of all output from the

console.

Tiger: The Pearl Tiger does not have an Add/Flash master.

10.6 Channel mimics

If you are in normal Run mode, the LEDs on each handle mimic the

intensity of the fixture or dimmer controlled by that handle (i.e. they

are lit if it is turned on).

If you are in Takeover Run mode (or Program mode), you can choose

between “Mimic” mode or “Fixture” mode, where the LEDs show you

which fixtures are selected for manual control.

You select the mode by holding down the Avo button and pressing

Softkey A. The button shows “Preset LEDs = Fixtures” (or mimics)

depending on the mode. You can also change this mode using the

Graphics Tablet.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 205 206

Sin comentarios

Chauvet Tiger DMX 60 Manual del operador Pagina 57