Chauvet Tiger DMX 60 Manual del operador descargar pdf (Pagina 129)

7. Chases - Page 161

Pearl 2008 Manual - 16th July 2007

of the chase when you turn it on.

You can save a speed with the chase, so that every time you play it

back, it runs at the same speed.

1> Press A [Chase Parameters].

2> Set the speed you want using the left hand wheel.

3> Press A [Save Speed].

• If you are in Run mode, you can also set the chase speed by

tapping G [Tap twice to set speed] in time with the music.

• You can change the speed display to BPM (beats per minute)

rather than seconds, from the User Settings menu (see page

201).

• If you are doing another operation using the wheels while running

a chase (e.g. manually positioning some fixtures), you can make

the wheels control speed and crossfade again by pressing the

Connect button next to the wheels, then the swop button for the

chase.

• You can set the chase back to its programmed speed by pressing

Connect, then A [Clear temporary speed].

The chase direction is controlled by the  (backwards),  (forwards)

and  (Bounce) buttons. These buttons can also be assigned as

Fixture control buttons (see page

127). Hold down the Avo button and

press Softkey B so the display shows [Chase Control Enabled] to use

the buttons to control the chase direction.

• You can save the current direction of the chase so it will always

start in that direction; Press A [Chase Parameters], then B [Save

Direction].

7.2.4 Manually controlling the chase steps

You can take manual control over the connected chase by pressing the

Stop button. If the chase is set to “Links Off”, it will do this

automatically - see the next section for details on Links.

• Press the Go button to restart playback of the chase

• The Snap Back button changes the chase direction the first time

you press it; a second press will jump back a step (times and

fades are ignored)

• To set the “next” step to be a particular step number, type the

step number on the numeric keypad then press Connect.

• Turn either wheel to manually control the fades for this step. You

can fade up or down until the fade completes; once a fade has

completed it stays at 100%. Once the Fade In, Fade Out and LTP

fades are all completed the chase will move on to the next step.

The display above the wheel shows the fade up and fade down of

the previous step as a percentage. This function can be disabled

using the chase parameters menu.

• The  and  buttons (next to the Go button) change the direction

of the chase. If the chase is stopped, these buttons jump

backwards and forwards a step.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 205 206

Comentarios a estos manuales

Sin comentarios

Chauvet Tiger DMX 60 Manual del operador Pagina 129

Comentarios a estos manuales