Chauvet Tiger DMX 60 Manual del operador descargar pdf (Pagina 171)

13. Other features - Page 203

Pearl 2008 Manual - 16th July 2007

‘AVOLITES’ directory, while ‘F – Wipe Fixtures’ deletes

‘AVOLITES/FIXTURES’. If you wish to keep other files on your memory

stick you should keep them out of these two directories, that way the

desk will never touch them, even if you do a ‘F – Wipe’. The directory

structure is the same on ‘AVOCACH’ as it is on any external drives.

13.1.3 Service mode

Service mode, selected by turning the key to “System” then pressing A

[Service], lets you make fundamental changes to the console, including

changing the operating software.

Do make sure you have plenty of time to complete these operations. Do

not attempt to upgrade the operating system or make other

fundamental changes just before showtime!

A [Run AVOS2] - AVOS2 is the low-level operating system of the

console. While AVOS2 is running, you can update the main

operating software in the console. See next section for AVOS2

functions.

B [Diagnostic Screen] - Displays a diagnostic screen which enables

you to test the buttons, faders and wheels on the console. Press

the Up arrow or turn the key back to Run mode to get out of

Diagnostic mode.

The top line of the display shows the Master Fader levels.

Below that are the settings of the Playback Swop buttons, Flash

buttons and faders.

Below that are the preset fader flash/swop buttons and the fader

levels themselves.

Whl1 and Whl2 give an incremental count from the wheels.

Timer and DMX show a count of internal timer ticks and DMX

packets sent.

DOM_resets indicates if resets of the DMX Output Module have

occurred; this is normally caused by the TMS micro becoming

loose in its socket. Try pushing it back into the socket.

Key shows key press and release codes for the buttons. X and Y

show graphics tablet pen coordinates.

XTAL=Good shows if the MIDI oscillator is running. On early

motherboards a modification was required.

C [Display Bus Errors] - A Bus error is generated when either the

software or hardware malfunctions. Up to 20 bus errors are

logged. Press ENTER while viewing the Bus errors to clear the list.

The Bus error Type and the Program counter value at the time of

the Bus Error are stored in the log. Should the Bus error have

been caused by a Software fault, then this information can be

used the pinpoint the precise location of the fault.

If a bus error has been logged then the letter 'E' appears on the

main LCD display positioned somewhere to the top left of the

Chase Window.

Most Bus errors are caused by a faulty or incorrectly inserted VDU

card. As a general rule, if a Bus error occurs, check that all the

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 205 206

Comentarios a estos manuales

Sin comentarios

Chauvet Tiger DMX 60 Manual del operador Pagina 171

Comentarios a estos manuales