Chauvet Tiger DMX 60 Manual del operador descargar pdf (Pagina 179)

13. Other features - Page 211

Pearl 2008 Manual - 16th July 2007

13.3 The stage remote (riggers remote)

The Pearl can be used with the optional Avolites Stage Remote. This is

a small hand-held controller which connects

to the console by a 25 pin serial cable. The

cable can be connected either way round and

can be plugged and unplugged at any time.

The remote is useful when setting up a show

as you can leave the console at the back of

the venue and use the Stage Remote to

operate it from the stage.

• To set up the stage remote, set the

console to Program mode. On the User

Settings menu, set option 7 to “Remote

Control” (hold down AVO and press

Softkey C to display the User Settings

menu). Plug in the remote. Press the

blank white key on the bottom left hand

corner of the remote, the LEDs should

flash. Press Exit, then 111. The LEDs

should flash again to say the remote is

enabled.

• To set a DMX channel to a particular

value, press DIM, type the DMX channel

number, press AT%, then 1-9 to set the

level or AT% again to set full. For

example, DIM 1 5 AT% AT% sets channel

15 to full.

• You can access the 4 DMX lines using the

following numbers:

Line A - Channels 1-512

Line B - Channels 513-1024

Line C - Channels 1025 - 1536

Line D - Channels 1537 - 2048

• The NEXT and LAST buttons turn on the channel after or the channel

before the one you just entered, at the last level you entered. Other

channels are turned off.

• You can use THRU to turn on a range of channels, for example 2 1

THRU 1 0 0 AT% 5 would turn on channels 21 to 100 at 50%.

• You can use the AND button to make up a list of channels to turn

on. For example, 2 1 THRU 3 0 AND 4 1 THRU 5 0 AT% 5 would

turn on channels 21-30 and 41-50 at 50%.

• Pressing INSTD sets all channels to 0.

• Recall a memory/chase by pressing MEM, then the playback

number, then AT%. The playback number is the button number on

the console, +15 if it’s on page B, +30 for page C, +45 for page D,

etc. Memories/chases are always turned on at 100%.

• For a chase you can use the + and - buttons to step forwards and

backwards. You can use this to focus lights if you program a chase

with one light on in each step.

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 205 206

Comentarios a estos manuales

Sin comentarios

Chauvet Tiger DMX 60 Manual del operador Pagina 179

Comentarios a estos manuales