Chauvet Tiger DMX 60 Manual del operador descargar pdf (Pagina 131)

7. Chases - Page 163

Pearl 2008 Manual - 16th July 2007

7.3.3 Editing a chase using Unfold

The Pearl has a powerful chase editing

system. The Unfold button places each

step of a chase on one of the playback

faders as if each step was a memory,

allowing you to turn on and edit each

step individually.

Tiger: If a chase has more than 10

steps, the Tiger Wing must be

connected to access steps 11-

15 on each page.

The display (right) shows the step

number, step legend, whether the

step is Simple or Complex, and

whether links are turned off (-) or on

(down arrow).

1> Press Unfold (one of the blue

command buttons), then the

Swop button of the chase to be

edited

2> The first 15 steps of the chase are loaded into playback faders 1-

15. The display shows details about the steps.

3> Raise a playback fader to output the contents of that step (fade

times will operate as programmed)

4> Various Unfold options are available, the details are below.

5> Press Unfold again to get out of unfold mode.

• To edit the contents of a step: Press Clear to empty the

programmer, raise the fader to output the step, make the

changes, press A [Record], then the Swop button (1-15) for the

step number.

• To change the times for the step, press B [Edit Times], then the

flash button for the step, then set the times (see Timing on the

following page)

• To Insert a new step, set up the lights for the new step, press C

[Insert], then the Swop button where you want to insert the new

step. The new step will be allocated to the button you press with a

step number half way between the steps either side, and all other

steps will be shifted along one. (You cannot use the blue Insert

button in Unfold mode).

• To Delete a step, press D [Delete] then the Swop button for the

step you want to delete, followed by Enter.

• You can copy a step by holding the Flash button of the step to

copy, then pressing the Swop button of the step to copy it to.

• You can renumber the chase to whole numbers by pressing C

[Insert], A [Renumber], then Enter to confirm.

• If the chase has more than 15 steps, you can swap to the next 15

steps using softkey F, or the previous 15 steps using softkey E.

• G [Shape Generator] allows you to insert and edit shapes in the

chase steps.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 205 206

Comentarios a estos manuales

Sin comentarios

Chauvet Tiger DMX 60 Manual del operador Pagina 131

Comentarios a estos manuales