Chauvet Tiger DMX 60 Manual del operador descargar pdf (Pagina 115)

6. Memories - Page 147

Pearl 2008 Manual - 16th July 2007

CHAPTER SIX

6. Memories

This chapter contains: HTP and LTP channels; how the Pearl works

when programming; recording a memory; playing back a memory;

changing playback pages; setting fade times for a memory; copying

and deleting memories; the include function; editing memories; the

“off” button; blind mode; recording the stage using snapshots; using

shapes in memories.

The Pearl has many functions for producing

a complex light show, and the most

fundamental part is a Memory, in which you

can store a “look” you have created using

your lights.

The Pearl has 450 playbacks, in 30 pages of

15, which can be used to store memories or

chases (sequences of “looks”). Chases are

covered in the next chapter. The playbacks

are controlled using the sliders and flash

buttons across the near edge of the console.

The roller is used to select the page of

memories or chases.

Tiger: On the Pearl Tiger, you need to connect the Tiger “wing” to use

playbacks 11-15 on each page.

The memory functions on the Pearl are very powerful; the first part of

this section explains the basics of how the Pearl uses memories.

6.1 Create

6.1.1 How the Pearl works when programming

The Pearl has a special internal memory called the “Programmer”.

Whenever you change an attribute of a fixture, the changes are stored

in the Programmer. When you record a memory, the contents of the

programmer are stored in the memory. Nothing else from the console

output is stored.

The Pearl has two programming modes, “Record by Fixture” (the

normal mode) and “Record by Channel”. The mode can be changed

using Softkey B when saving a memory, or from User Setting 1 (hold

the AVO button and press C [User Settings]). The differences are:

• Record by Fixture - When you change any attribute of a fixture,

all the other attributes are placed in the Programmer as well. You

will get exactly the result you expected when you recall the

memory, but you can’t combine memories containing the same

fixtures, because the new memory will just override the old one.

• Record by Channel - Only the attribute you change is placed in

the programmer. This means you can save memories which only

contain position information, then recall them with other memories

to set colours, gobos etc. This is much more flexible but requires

more programming initially, because you need several memories

Playback faders & roller

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 205 206

Comentarios a estos manuales

Sin comentarios

Chauvet Tiger DMX 60 Manual del operador Pagina 115

Comentarios a estos manuales