Chauvet Scorpion Dual Manual de usuario descargar pdf (Pagina 12)

Page 12 of 64 Scorpion™ Dual User Manual Rev. 1

3. SETUP

AC Power

The Scorpion™ Dual has an external auto-

ranging power supply and it can work with an

input voltage range of 100 to 240 VAC, 50/60 Hz.

To determine the product’s power requirements (

circuit breaker, power outlet, and

wiring), use the current value listed on the label affixed to the product

’s back panel, or

refer to the Technical Specifications. The listed current rating indicates the product’s

average current draw under normal conditions.

Always connect the product to a protected circuit (circu

it breaker or fuse). Make

sure the product has

an appropriate electrical ground to avoid the risk of

electrocution or fire.

Never connect the product to

a rheostat (variable resistor) or dimmer circuit, even

if the rheostat or dimmer channel serves only as a 0 to 100% switch.

Fuse

Replacement

Disconnect the product from power before replacing the fuse.

1. Disconnect the product from power.

2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.

3. Pry the fuse holder out of the housing.

4. Remove the blown fuse from the holder.

5. Replace with a fuse of the exact same type and rating.

6. Insert the fuse holder back in place and reconnect power.

A spare fuse is not included; however, the safety cap has room for a spare.

Always replace a blown fuse with one of the same type and rating.

Installed fuse

(held by plastic clip)

Spare fuse holder

(inside safety cap)

Safety cap

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

Sin comentarios

Chauvet Scorpion Dual Manual de usuario Pagina 12