Chauvet SCAN LED 200 Manual de usuario descargar pdf (Pagina 17)

5. Appendix 17 12/9/2010 10:32 AM

3-Pin to 5-Pin Conversion Chart

If you use a controller with a 5-pin DMX output connector, you will need to use a 5-pin to

3-pin adapter. The chart below details a proper cable conversion:

3-P

IN TO

5-P

ONVERSION

HART

Conductor 3-Pin Female (Output) 5-Pin Male (Input)

Ground/Shield Pin 1 Pin 1

Data ( - ) signal Pin 2 Pin 2

Data ( + ) signal Pin 3 Pin 3

Not used Pin 4

Not used Pin 5

Setting up a DMX Daisy Chain

1. Connect the (male) 3-pin connector side of

the DMX cable to the output (female) 3-pin

connector of the controller.

2. Connect the end of the cable coming from the

controller which will have a (female) 3-pin

connector to the input connector of the next

fixture consisting of a (male) 3-pin connector.

3. Then, proceed to connect from the output as

stated above to the input of the following

fixture and so on.

Universal DMX Controller

This drawing

provides a general

illustration of the

DMX input/output

panel of a lighting

fixture.

Continue the link

1 2 ... 12 13 14 15 16 17 18 19

Sin comentarios

Chauvet SCAN LED 200 Manual de usuario Pagina 17