Chauvet SCAN LED 200 Manual de usuario descargar pdf (Pagina 10)

4. Operating Instructions 10 12/9/2010 10:32 AM

Operation

DMX Operation

This is the operating mode which will allow for control with an external DMX controller. You must set the

starting address for this mode. If this is your first time using DMX, then it is recommended that you refer

to the “DMX Primer” section in the “Appendix” of this manual.

1. Press <MODE/ESC> until d*** appears on the LED screen.

2. Using <UP> and <DOWN>, select the starting address (001~512).

3. Press <ENTER>.

4. Press <MODE/ESC> until one of the DMX personalities appears on the LED screen

(8-CH, 5-CH).

5. Using <UP> and <DOWN>, select the desired DMX personality.

6. Press <ENTER>.

Only connect 32 fixtures to a single DMX daisy chain!

Master/Slave Mode (Sound-Active, Auto Mode)

This mode allows a single unit, the master, to operate in one of the standalone modes, while one or

more fixtures, slaves, synchronize their responses to the master.

Master:

The master fixture may be set in any of the STANDALONE modes: sound-active, fast, or slow.

Slave:

1. Press <MODE/ESC> until one of the standalone modes appears on the LED screen

(SLAv, NStS, NAFA, NASL).

2. Using <UP> and <DOWN>, select SLAv.

3. Press < ENTER >.

Only connect 31 slave fixtures when operating in this mode!

Automatic-Slow

This fixture has a preprogrammed chase that will operate in a preprogrammed, slow playback

speed.

Access this mode via the control panel on the front of the fixture. Please see the instructions

below for further explanation.

1. Press <MODE/ESC> until one of the standalone modes appears on the LED screen

(SLAv, NStS, NAFA, NASL).

2. Using <UP> and <DOWN>, select NASL.

3. Press <ENTER>.

Automatic-Fast

This fixture has a preprogrammed chase that will operate in a preprogrammed, fast playback

speed.

Access this mode via the control panel on the front of the fixture. Please see the instructions

below for further explanation.

1. Press <MODE/ESC> until one of the standalone modes appears on the LED screen

(SLAv, NStS, NAFA, NASL).

2. Using <UP> and <DOWN>, select NAFA.

3. Press <ENTER>.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Comentarios a estos manuales

Sin comentarios

Chauvet SCAN LED 200 Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Reflectores Chauvet SCAN LED 200