Chauvet MINWASH DMX-512 Manual de usuario descargar pdf (Pagina 19)

5. Appendix 19 6/14/2010 4:13 PM

This drawing

provides a general

illustration of the

DMX input/output

panel of a lighting

fixture.

Universal DMX Controller

Continue the link

3-Pin to 5-Pin Conversion Chart

If you use a controller with a 5-pin DMX output connector, you will need to use a 5-

pin to 3-pin adapter. The chart below details a proper cable conversion:

3-P

IN TO

5-P

ONVERSION

HART

Conductor 3-Pin Female (Output) 5-Pin Male (Input)

Ground/Shield Pin 1 Pin 1

Data ( - ) signal Pin 2 Pin 2

Data ( + ) signal Pin 3 Pin 3

Not used Pin 4

Not used Pin 5

Setting up a DMX Serial Data Link

1. Connect the (male) 3-pin connector side of

the DMX cable to the output (female) 3-pin

connector of the controller.

2. Connect the end of the cable coming from

the controller which will have a (female)

3-pin connector to the input connector of the

next fixture consisting of a (male) 3-pin

connector.

3. Then, proceed to connect from the output as

stated above to the input of the following

fixture and so

1 2 ... 14 15 16 17 18 19 20 21 22

Sin comentarios

Chauvet MINWASH DMX-512 Manual de usuario Pagina 19