Chauvet Geyser Manual de usuario descargar pdf (Pagina 15)

Geyser™ RGB User Manual Rev. 7 Page 15 of 18

General Troubleshooting

Symptom Display Possible Cause Possible Action

No output or

low output or

fog machine is

spitting fluid

“Addr” or “HEAT”

Wrong fluid

Clean thoroughly with CHAUVET® FCQ. For

full instructions, see Fogger Maintenance. Refill

with CHAUVET® water-based fog fluid.

Blocked pipes or

failing part

Contact Customer Service

Circuit breaker or fuse

keeps blowing

Off

Excessive load on the

circuit

Make sure that the total load does not exceed

80% of the breaker or fuse nominal current

Short circuit along the

power lines

Check the power lines and power cords

Product does not

power up

Off

No energy on power

outlet

Check power outlet

Change to another outlet

Loose or damaged

power cord

Check the power cord

Blown fuse

Replace blown fuse with a good one of the

same type and rating

Internal problem

Send product for repair

Product does not

output fog

“Addr” or “HEAT”

No fluid

Turn the product off and replenish the fog fluid

(use only CHAUVET® water-based fog fluid)

Heater or pump

clogged

Clean thoroughly with CHAUVET® FCQ. For

full instructions, see Fogger Maintenance. Refill

with CHAUVET® water-based fog fluid.

Wired remote

disconnected or

defective

Make sure that the remote is connected

Try the remote on another Geyser™ RGB if

available

Inappropriate wired

remote operation

See Wireless Remote Control for instructions

Wireless remote

receiver not

connected

Make sure that the wireless remote receiver is

connected

Wireless remote

transmitter ran out of

battery

Replace battery on wireless remote transmitter

Internal problem

Send the product for repair

If you still experience problems after trying the above solutions, contact Chauvet

Technical Support.

1 2 ... 10 11 12 13 14 15 16 17 18

Comentarios a estos manuales

Sin comentarios