
Geyser™ RGB User Manual Rev. 7 Page 11 of 18
4. OPERATION
To access the control panel functions, use the four buttons located underneath the
display.
<MENU>
Selects an operation mode or to backs out of the current menu option
(<UP>)
Scrolls up the list of options or selects a higher value
(
)
Scrolls down the list of options or selects a lower value
<ENTER>
Activates a menu option or a selected value
Mode Programming Steps Description
DMX Mode Addr 1–512
Selects the DMX starting address
Color Program CH-1–CH-4
Color program off (default)
Co 1–Co 9
Selects preset colors
rAnd
Selects random color program
Fluid Sensor orL
Selects fluid sensor to on or off
oFF
The Geyser™ RGB Wireless Remote Control buttons 1–4 trigger the options set in
the color programs CH-1–CH-4, respectively.
(DMX)
Set the product in DMX mode to control with a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
3. Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
Starting Address
When selecting a
starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you
choose a starting address that is too high, you could
restrict the access to some of the product’s channels.
The Geyser™ RGB uses up to 8 DMX channels in its 8-Channel
highest configurable address to 505.
If unfamiliar with DMX, download the DMX Primer from www.chauvetlighting.com.
To select the starting address, do the following:
1. Press <MENU> repeatedly until Addr shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select the starting address.
HEAT shows on the display when you first turn the product on and intermittently
during the heat-up time of the fog fluid; however, you
can configure the product
during this time.
Comentarios a estos manuales