
LX-5 User Manual 6 Rev. 2
General Troubleshooting
Symptom Solution(s)
Lights
& Snow Controllers
& Chaser
Check fan thermal switch reset
Beam is very dim or
not bright
Clean optical system or replace lamp
Check 220/110v switch for proper setting
Breaker/Fuse keeps
blowing
Check total load placed on device
Check users manual for speed adjustment
Check for power on Mains.
Check device’s fuse. (internal and/or external)
there is no
movement to the
Make sure you have the correct audio mode on the
control switches. If audio provided via ¼” jack, make
sure a live audio signal exists
Adjust sound sensitivity knob
Lamps cuts off
sporadically
Possible bad lamp or product is overheating.
Lamp may be at end of its life.
on after power failure
Some discharge lamps require a cooling off period
before the electronics in the product can kick start it
again, wait 5 to 10 minutes before powering up
Check 220/110v switch for proper setting
Re-install bulb, may have shifted in shipping
Check slip ring & brushes for contact
Install bulb
Check reset switch
Check cable connections
Make sure connector is firmly connected to device
All Chauvet lighting products featuring stand-alone
functions do not require additional settings, simply
power the product and it will automatically enter into
this mode
If you still have a problem after trying these solutions, please contact CHAUVET® Technical
Support.
Comentarios a estos manuales