Chauvet Scorpion Scan 3D EU Manual de usuario descargar pdf (Pagina 7)

Setup

Page 7 of 44

4. SETUP

AC Power

The Scorpion™ Scan 3D EU has an auto-ranging power supply and it can work with an input voltage

range of 100~240 VAC, 50/60 Hz.

To determine the product’s power requirements (circuit breaker, power outlet, and wiring),

use the

current value listed on the label affixed to the product’s back panel, or refer to the product

’s

specifications chart. The listed current rating indicates the product’s

average current draw under

normal conditions.

Always connect the product to a protected circuit (circuit breaker or fuse). Make sure

the product has

an appropriate electrical ground to avoid the risk of electrocution or

fire.

Never connect the product to

a rheostat (variable resistor) or dimmer circuit, even if

the rheostat or dimmer channel serves only as a 0~100% switch.

If the power input cord that came with your product has no plug or you need to change the plug, use

the table to wire the new plug:

Cable (EU)

International

Brown

Live

Light Blue

Neutral

Yellow/Green

Earth

Disconnect the product from power before replacing the fuse.

Fuse Replacement

1. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.

2. Pry the fuse holder out of the housing.

3. Remove the blown fuse from the holder and replace with a fuse of the exact same type and rating.

4. Insert the fuse holder back in place and reconnect power.

The product does not ship with a spare fuse; however, the safety cap has room for a

spare.

Always replace a blown fuse with the same type and rating.

Mounting

CAUTION! Adhere to the respective national legal requirements for laser use during mounting!

Mounting must only be carried out by qualified persons!

Before mounting, read and follow ALL

the safety recommendations in this manual.

Orientation

The Scorpion™ Scan 3D EU is designed for overhead mounting. Make sure adequate ventilation is

provided around the product. Be sure to use a suitable hanging clamp and safety cable. Accessories

needed for safe and effective mounting are available from your local lighting distributor.

Installed fuse

(held by plastic clip)

Spare fuse holder

(inside safety cap)

Safety cap

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Comentarios a estos manuales

Sin comentarios

Chauvet Scorpion Scan 3D EU Manual de usuario Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Reflectores Chauvet Scorpion Scan 3D EU