Chauvet Impulse Manual de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 21
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
Impulse™ 648 User Manual Rev. 6 Page 15 of 21
General Troubleshooting
Symptom Possible Cause Possible Action
Circuit breaker or fuse
keeps blowing
Excessive load on the circuit
Make sure that the total load does not
exceed 80% of the breaker or fuse
nominal current
Short circuit along the power lines
Check the power lines and power cords
Product does not power
up
No energy on power outlet
Check power outlet
Change to another outlet
Loose or damaged power cord
Check the power cord
Blown fuse
Replace blown fuse with a good one of
the same type and rating
Internal problem
Send product for repair
Product does not
respond to DMX
Wrong starting address on the
product
Set the correct starting address on the
product
Use the right fader(s) on the controller
Wrong DMX personality on the
product
Set the correct DMX products
personality
Assign the faders accordingly
Wrong polarity setting on the DMX
controller
Change the signal polarity on the
controller
Loose or damaged DMX cable
Check the DMX cable before the faulty
unit
Internal problem
Send product for repair
Intermittent DMX
Problems
Signal cables are not DMX
compatible
Replace non DMX cables with true
DMX cables
Interference with AC or radio
signals
Keep DMX cables away from AC wires
or radio equipment
DMX cable too long Install an optically coupled DMX
amplifier right before the product with
intermittent problems
Too many products connected Install an optically coupled DMX
amplifier after unit #32
Terminator not connected
Install a terminator, as indicated in the
DMX Primer section.
If you still experience problems after trying the above solutions, contact
CHAUVET® Technical Support.
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21

Comentarios a estos manuales

Sin comentarios