Chauvet Data Stream 4 Manual de usuario descargar pdf (Pagina 6)

Page 6 of 12 DataStream™ 4 User Manual Rev. 1

3. SETUP

AC Power

This product has an auto-ranging

power supply and it can work with an input voltage of

100 to 240 VAC, 50/60 Hz.

To determine the power requirements for this product

(power outlet and wiring), use the

current value listed on the label affixed to the product

’s back panel, or refer to the

product’s specifications chart. The listed current rating indicates the product’s average

current draw under normal conditions.

•

Always connect this product to a protected circuit (circuit breaker or fuse),

making sure that it has an appropriate electrical ground to avoid the risk of

electrocution or fire.

• To eliminate wear and improve its lifespan, during periods of non-use

completely disconnect from power via breaker or by unplugging it.

Never connect this product

to a rheostat (variable resistor) or dimmer circuit,

even if the rheostat or dimmer channel serves only as a 0 to 100% switch.

Fuse

Replacement

1. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.

2. Pry the fuse holder out of the housing.

3. Remove the blown fuse from the holder and replace with a fuse of the exact same

type and rating.

4. Insert the fuse holder back in place and reconnect power.

Disconnect the product from the power outlet before replacing the fuse.

Installed fuse

(held by plastic clip)

Spare fuse holder

(inside safety cap)

Safety cap

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Chauvet Data Stream 4 Manual de usuario Pagina 6