Chauvet Q-Spot 575 Manual de usuario

Snapshot Ok on Dimmer Outdoor OK Sound Activated DMX512 Master/Slave Multitap Transformer Replaceable Fuse User Serviceable Duty Cycle Q-Wash 57

Master/SlOften, the setup for Master-Slave and Standalone operation requires that the first fixture in the chain be initialized for this purpose via e

Q-Wash 575 User Manual 11 2007-01-02/12:55 STRUCTIONS Navigating the Control Panel Dis The Control Panel LED Display shows the menu items you se

Menu Map Q-Wash 575 User Manual 12 2007-01-02/12:55

Control Panel Functions FUNCTION OPTIONS NOTES NO/YES Pan Invert (Yes or No) NO/YES Tilt Invert (Yes or No) 001-497 DMX Channel Address YES

User Configurations TO SET THE PAN TO IN NG G: 1) Press <M E> until VERTI OR NON-INVERTINOD is displayed. 2) Use the <UP> and <DOWN

Master/Slave Mode (Master Sound, Master Auto): w you to link up to 32 units together without a controller. the DMX connector on the rear t fixture. F

018 Ù 035 036 Ù 051 Red Blue 052 Ù 071 Green 072 Ù 089 090 Ù 107 108 Ù 127 128 Ù 187 188 Ù 195 Purple Color Correction: 6000K Color Correction: 3200K

General Troubles Applies to hootingSymptom Solution(s) Lights Foggers & Snow Controllers Dimmers& Chaser Auto shut off Check f9 an ther

Technical Support d, FL 33020 (U.S.A.) Support (Email): [email protected] Telephone: (954) 929-1115 - (Press 4) Fax: (954) 929-5560 - (Attentio

Returns Procedure Returned merchandise must be sent prepaid and in the original packing, call tags will not be issued. erchandise Authorization Number

TABLE OF CONTENTS 1. BEFORE YOU BEGIN...

1. BEFORE YOU BEGIN What is included ¾ 1 x Q-Wash 575™ ¾ HMI 575W Lamp ¾ Power Cord ¾ Warranty Card ¾ User Manual Unpacking Instructions Immediatel

Contact Us World Wide General Information Chauvet Lighting 3000 North 29th Court Hollywood, FL 33020 voice: 954.929.1115 fax: 954.929.5560 toll free:

2. INTRODUCTION Features • 16-channel DMX-512 moving yoke color wash • Pan: 530° / tilt: 280° • Variable strobe/shutter • CMY color mix system (cyan

Product Overview Control Panel Access Plate to Multitap Transformer Head Yoke Base Carrying Handle Power Connector & Fus

3. SETUP Lamp You will need to install a lamp prior to the initial operation of the fixture. A 575W HMI lamp is included. Warning! When replacing th

Disconnect the power cord before replacing a fuse and always replace with the same type fuse. Fuse Replacement The fuse is located inside this compa

CABLE CONNECTORS This drawing provides a general illustration of the DMX Input/Output panel of a lighting fixture. U X Controller niversal DMContinue